Nieco JF64-BG Manuel d'utilisateur télécharger pdf (Page 15)

D. CLEANING ANDDISASSEMBLY

Turn broiler off and close the main gas valve. Disconnect the power supply to the broiler before cleaning or

servicing. If this broiler is connected using a restraint, and disconnection of the restraint is necessary for clean-

ing or moving the broiler, the restraint must be reconnected after the broiler has been returned to its originally

installed position. Allow to cool for 30 minutes prior to cleaning/disassembly. Leave the ventilation system on

during cooling. Use only approved cleaning, degreasing and sanitizing solutions.

ALL PARTS ARE CLEANED ON A DAILY BASIS UNLESS OTHERWISE NOTED

Follow the steps for proper disassembly. Reverse the order for reassembly.

CAUTION

FOLLOW THE DISASSEMBLY AND

REASSEMBLY STEPS TO ENSURE

PROPER OPERATION OF THE BROIL-

ER. FAILURE TO DO SO MAY RESULT

IN OPERATIONAL PROBLEMS.

WARNING

BROILER PARTS ARE HOT. DO

NOTATTEMPTTODISASSEMBLE

THEBROILERUNTILITISFULLY

COOL. FAILURE TO FOLLOW THIS

INSTRUCTION MAY RESULT IN

SEVERE INJURY.

WARNING

LEAVETHEVENTILATIONHOOD

ONDURING COOLING. FAILURE

TO DO SO COULD POSE A FIRE

SAFETY HAZARD.

Nieco Corporation - Model JF64-BG

How to read the cleaning section

The location of the part.

Pull each meat guide out slightly from the bottom,

then lift off .

W ash, rinse, and sanitize in the 3- compar tment

sink.

Meat Guides

Feed End

Tools

Instructions

3- Compartment Sink

Clean: Every 4 hours

Scrub Pad

When to clean the part.

Picture of the part to

be removed and

cleaned.

How to remove and

clean the parts.

The tools needed

to clean the part

The name of the part to be

cleaned.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 34 35

Commentaires sur ces manuels

Pas de commentaire

Nieco JF64-BG Manuel d'utilisateur Page 15

Commentaires sur ces manuels

Produits connexes et manuels pour Four Nieco JF64-BG